Outline Of Functions; Hdd; Mega Pixel Camera Compatibility And Capacity; Replace Hdds - Panasonic WJ-ND400 Installation Manual

ND400_Basic.book 16 ページ ２００８年４月８日 火曜日 午後３時５９分

Outline of Functions

Description of Functions

HDD

Mega Pixel Camera Compatibility and
Capacity
The recorder can record high-definition images (mega pixel camera
images) in SXGA (1280 x 960) JPEG four times that of the existing
VGA (640 x 480). This makes it possible to record a wide angle of
view and to zoom in without fuzziness to check things.
Display on 21 in PC monitor
SXGA (1280 x 960) pixels
You can install up to 9 HDDs to record high-quality images for long
periods of time. Plus, you can add up to 5 extension units.

Replace HDDs

Replacement is Easy
You can install and remove HDDs by opening the front panel.
If more than two HDDs are installed, replacement can be done
without stopping recording. Instructions are shown on the LCD to
reduce misoperations, and make maintaining and replacing HDDs
easy.
Use the special HDD canister provided to install the HDD.
The HDD unit is an HDD that is in the special canister. The HDD
units can be easily installed or removed from the HDD bay slots
inside the front cover.
* Contact your dealer for information on purchasing and replacing
HDDs.
16

HDD Space Management

The HDDs in the recorder are virtually divided in the 4 image areas
shown below (refer to the Setup Instructions (PDF file)).
You can set only one area for each HDD.
Conventional VGA
(640 x 480) pixels
(1) Normal Recording Area
(2) Event Recording Area
(3) Pre-event Recording Area
(4) Copy area
Note:
•
•
•
Normal Recording Area
Event Recording Area
Pre-event Recording
Area
Copy Area
You can check the remaining capacity
for each area on the Setup menu.
Area for recording except events.
Manual recording/schedule recording/SD memory data
Area for recording when events occur.
Post-event recording/emergency recording
Area for pre-event recording.
Area where copied data is saved.
The HDD provided in the recorder at the factory is initialized as
normal recording area. Unformatted HDDs inserted into the
recorder are automatically initialized as normal recording area.
Recording/playback is not possible if only the Pre-event
Recording Area and the Copy Area are created. Create either
one normal recording area or event recording area.
If a normal recording area is not created, manual and schedule
recordings are recorded to the event recording area. Also, if an
event recording area is not created, event and emergency
recordings are recorded to the normal recording area.
(1)
(2)
(3)
(4)