Connections - Panasonic WV-CL920 Operating Instructions Manual

CONNECTIONS

A. WV-CL920 (120 V AC 60Hz)
1. Plug the AC power cord (supplied as standard
accessory) into the AC Inlet Socket.
2. Connect the AC power cord to a 120 V AC 60 Hz
outlet.
Notes:
• Connect the power cord firmly.
• The power cord should be long enough for pan-
ning and tilting.
If the cable is too short, the power cord plug may
be pulled off the camera when the camera pans or
tilts.
B. WV-CL924 (12 V DC/24 V AC)
The WV-CL924 has an AC/DC compatible input termi-
nal. The 12 V DC or 24 V AC power supply cord can be
connected to this terminal. The camera detects the
power source automatically.
1. 12 V DC Power Supply
Connect the power cord to
the AC/DC compatible
input terminal on the rear
panel of the camera.
DC 12V AC 24V
IN IN
1
2
12 V DC
GND
(10.8 V - 16 V)
-9-
Resistance of copper wire [at 20°C (68°F)]
Copper wire #24
size (AWG) (0.22 mm
2
Resistance 0.078
/m
Resistance 0.026
/ft
• Calculation of maximum cable length between
camera and power supply.
10.8 V DC V (R x 0.42 x L)
A
L : Cable length (m)
R : Resistance of copper wire ( /m)
V : DC output voltage of power supply unit
A
V
A
L standard =
0.42 x R
V
A
L minimum =
0.42 x R
V 10.5
A
L maximum =
0.42 x R
#22 #20 #18
) (0.33 mm ) (0.52 mm ) (0.83 mm
2 2
0.050 0.030 0.018
0.017 0.010 0.006
16 V DC
12
(m)
16
(m)
(m)
)
2