Panasonic WV-CL920 Operating Instructions Manual page 37

Default: OFF
AUTO1: The camera selects black and white mode
if the picture is dark, or color mode if the pic-
ture is bright enough.
Note: Color picture switches to black-and-
white picture and vice versa in approxi-
mately 1 or 2 minutes after recognition of
illuminance.
AUTO2: Applying AUTO1 may cause malfunction
when using a source of near-infrared light at
night because the illuminance changes signifi-
cantly when switching between the color pic-
ture and the black-and-white picture.
AUTO2 allows the unit to prevent malfunction
because it simply recognizes a source of light.
Note: Because a source of light is simply rec-
ognized based on the information from
CCD image pickup element, an object
sometimes can not be recognized suc-
cessfully when the object is always mov-
ing or the object and its background have
the same color.
When you apply this mode, AUTO2, the
wavelength of the light source should be
800 nm or more.
ON: Black and white mode is selected.
OFF: Color mode is selected.
UP SIDE DOWN
CHROMA GAIN
AP GAIN
PEDESTAL
HUE
BW
BURST (BW)
CAMERA RESET
RET
10.7 BURST (BW)
1. Move the cursor to the BURST (BW) parameter.
But
2. Select ON or OFF using
Default: ON
ON: The burst signal is supplied along with the
black and white composite video signal.
OFF: The burst signal is not output.
Note: We recommend that you usually select
ON.
UP SIDE DOWN
CHROMA GAIN
AP GAIN
PEDESTAL
HUE
BW
BURST (BW)
CAMERA RESET
RET
-38-
** SPECIAL **
OFF
....I....
....I....
....I....
....I....
- +
OFF
ON
PUSH SW
END
or .
** SPECIAL **
OFF
....I....
....I....
....I....
....I....
- +
OFF
ON
PUSH SW
END