Setup Operation - Panasonic WV-CL920 Operating Instructions Manual

2. SETUP OPERATION

This camera utilizes a user setup menu (CAM SET UP)
that is displayed on the monitor.
To set items on the CAM SET UP menu, use the follow-
ing buttons on the side panel.
Left Button
Set Switch
Up Button ( ): Moves the cursor upwards. Use
this button to select an item or
adjust the parameters.
Down Button ( ): Moves the cursor downwards. Use
this button to select an item or
adjust the parameters.
Right Button ( ): Moves the cursor to the right. Use
this button to select or adjust the
parameters of the selected item.
The parameter changes each time
this button is pressed.
Left Button (
Set Button (
Up Button
Right Button
To return to the CAM SET UP menu move the cur-
sor to RET and press
Down Button
• All Reset Operation
All Reset allows you to reset all setup menu items to the
factory settings if you are unsure about the correct set-
tings. Proceed as follows:
(1) Make sure that the CAM SET UP menu is not dis-
played (a camera picture is displayed).
(2) While pressing both
few seconds. The message ALL RESET momentari-
ly appears on the monitor.
This resets all adjustments and parameters to the
factory default settings.
-19-
): Moves the cursor to the left. Use
this button to select or adjust the
parameters of the selected item.
The parameter changes each time
this button is pressed.
): Executes selection and displays a
submenu for an item with
END: Close Setup menu.
RET: Return to the previous menu
or page.
.
and , press
mark.
for a