Panasonic WV-CL920 Operating Instructions Manual page 32

• To reset COARSE and FINE to the values pre-
set at the factory, press
neously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the AC
line phase.
• If the AC line contains noise (spike noise, etc.),
the stability of the vertical phase of the camera
video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7-1. Auto-Tracing White Balance Mode (ATW)
You can select one of four modes for white balance
adjustment as follows:
• ATW1 (Auto Tracing White Balance 1)
In this mode, the color temperature is monitored
continuously and thereby white balance is set auto-
matically. The color temperature range for the prop-
er white balance is approximately 2 600 - 6 000K.
Proper white balance may not be obtained under
the following conditions:
1. The color temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high color
temperature objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
and simulta-
-33-
Move the cursor to the WHITE BAL parameter and
select ATW1. The white balance of the camera is
automatically set.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END SET UP ENABLE
• ATW2 (Auto Tracing White Balance 2)
Auto-tracing white balance of the sodium light
mode (ATW2)
In case that you select ATW2 for sodium light,
white balance is set automatically (Operation is not
needed).
Note: ATW1 and ATW2 do not appear for the
WHITE BAL parameter on the system con-
troller setup menu.
OFF
ALC
OFF
ON (DNR-H)
OFF
INT
ATW1
OFF
DC