Camera.operation.setting.[Camera.setup]; Register.a.scene.file.[Scene1/Scene2]; Light.quantity.control.method.selection.[Alc/Elc] - Panasonic WV-CP630/G Operating Instructions Manual

Camera operation setting [CAMERA SETUP]
The following describes the camera operation settings. The following settings can be configured on the "CAMERA SETUP"
screen displayed from the top screen.
Refer to page 5 for how to call up the screen.
The settings configured on the "CAMERA SETUP" screen will be saved as a scene file.
1. Register a scene file [SCENE1/SCENE2]
There are two scene modes. When strong sunshine reflection exists in the operational environment, SCENE1 is recommended; when
indoor lighting is sufficient without sunshine reflection, SCENE2 is recommended. Change between the scene files can be made by
shortcut operation. (☞ page 27) The default setting is "SCENE1".
Screen when "SCENE1" is selected
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&N(IR)
AUTO1
VMD OFF
RET TOP END
Step 1
After confirming that "SCENE1" is selected, configure the settings of "ALC/ELC" through "VMD". (☞ page 8-17)
To change the scene files, go to step 2.
Step 2
Move the cursor to "SCENE1" and press the [RIGHT] or [LEFT] button to select "SCENE2".
→ The screen changes and displays "SCENE2".
Step 3
Set the items you want to change.
The number displayed at the right side of the title on each setting screen indicates a scene file
number.
Step 4
Move the cursor to "SCENE2" and press the [RIGHT] or [LEFT] button to select "SCENE1" to
resume normal operation.
2. Light quantity control method selection [ALC/ELC]
The method of controlling the quantity of light is selected from the following in accordance with the lens to be used.
ALC (default): The iris of the lens is automatically adjusted in accordance with the brightness of a subject. Select "ALC" when using
an ALC lens.
ALC+: Controls the quantity of light with a combination of the electronic shutter and auto iris. This selection is suitable at shooting
a bright subject such as an outdoor subject with auto iris lens. Be aware that flicker may occur when a subject is under
fluorescent lighting.
ELC: Controls the quantity of light with the electronic shutter. This selection is suitable for use of a lens with fixed iris or manual iris.
8
Screen when "SCENE2" is selected
**CAMERA SETUP**
SCENE2
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&N(IR)
AUTO1
VMD OFF
RET TOP END
"SYSTEM SETUP" screen
Scene file
**ALC CONT**(1)
number
BACK LIGHT COMP
SUPER-D6 ON
HLC ---
FOG COMP ---
LEVEL .I..... 0
- +
RET TOP END