Setup; Camera Setup Menu; Setup Operation - Panasonic WV-CF250 Operating Instructions Manual

SETUP

1. CAMERA SETUP MENU

This camera utilizes a user setup menu that is displayed on-screen.
The setup menu contains various items that form a tree-type structure as shown below.
It is described in the following section : "2. SETUP OPERATION."
Camera
ID
ON/OFF
Camera SUPER-D
ID ON
Editing
Camera ID Manual
Display Level
Position Selection

2. SETUP OPERATION

This camera utilizes a user setup menu (CAM SET
UP) that is displayed on the monitor.
To set items on the CAM SET UP menu, use the fol-
lowing buttons on the side panel.
Left Button
Set Switch
(U) (Up Button):
This button is used to move the cursor
upwards. Use this button to select an item
or adjust the parameters.
(D) (Down Button):
This button is used to move the cursor
downwards. Use this button to select an
item or adjust the parameters.
(R) (Right Button):
This button is used to move the cursor to
the right. Use this button to select or adjust
SET UP DISABLE SET UP ENABLE
Light
Control
ALC ELC
SUPER-D
OFF
Manual Manual
Mask Area Level
Selection Selection
Up Button
Right Button
Down Button
CAM SET UP
Shutter AGC
Speed ON/OFF
INT
Manual
Selection
Manual
Mask Area
Selection
the parameters of the selected item. The
parameter changes each time this button is
pressed.
(L) (Left Button):
This button is used to move the cursor to
the left. Use this button to select or adjust
the parameters of the selected item. The
parameter changes each time this button is
pressed.
(S) (Set Button):
This button is used to set the determined
parameter. If the item has its own setting
menu (as indicated by
ton to display the setting menu.
• All Reset Operation
All Reset allows you to reset all setup menu items
to the factory settings if you are unsure about the
correct settings. Proceed as follows:
(1) Make sure that the CAM SET UP menu is not
displayed (a camera picture is displayed).
(2) While pressing both
(S) for a few seconds. The words ALL
RESET momentarily appear on the monitor.
At this time all adjustments and parameters are
reset to the factory default settings.
-12-
SYNC
INT/LL
LL VD2
Manual Automatic
Selection Selection
V. Phase
Manual
Adjustment
), press this but-
(L) and (R), press