Table of Contents
Advertisement
DIMENSIONS OF MOUNTING BRACKET
Caution on installation
Use wood screws with the cam-
era mounting bracket that are
suitable for Installation into a
wood
base
of
dimensions and strength. For
installation in a material other
than wood, refer servicing to
qualified service personnel.
SETUP
1. CAMERA SETUP MENU
This camera utilizes a user setup menu that is displayed on-screen.
• Opening the Setup Menu
Press and hold down
more.
The CAM SET UP menu appears on the
monitor as shown at right.
Check the current settings on the menu.
Refer to the sections below for a detailed description of menu items. If you decide not to
make any changes after checking the current settings, move the cursor to END at the start
of the bottom line, and press
era picture mode.
Note: If no button is pressed for 5 minutes while the CAM SET UP menu or any other menu
is opened, the menu is automatically closed and the mode returns to the normal cam-
era picture.
2. SETUP OPERATION
This camera utilizes a user setup menu
(CAM SET UP) that is displayed on the
monitor.
To set items on the CAM SET UP menu, use
the following buttons on the side panel.
Up Button (
):
Down Button (
): Moves the cursor downwards. Use this button to select an item or
Right Button (
): Moves the cursor to the right. Use this button to select or adjust the
Left Button (
):
Set Button (
):
To return to the CAM SET UP menu
Move the cursor to RET and press
• All Reset Operation
All Reset allows you to reset all setup menu items to the factory default settings if you are
unsure about the correct settings. Proceed as follows:
(1) Make sure that the CAM SET UP menu is not displayed (a camera picture is displayed).
(2) While pressing both
RESET momentarily appears on the monitor.
This resets all adjustments and parameters to the factory default settings.
• Editing the CAM SET UP Menu
Important Notice:
When the SET UP DISABLE appears in the bottom line of the CAM SET UP menu, you
cannot change the currently active settings. This is to prevent accidental changing of
the settings.
To edit the CAM SET UP menu (change
settings), press
and
to move the cursor to SET UP
DISABLE in the bottom line.
Press
. SET UP DISABLE changes
to SET UP ENABLE. Move the cursor to
END, then to the item(s) you want to
change.
appropriate
for 2 seconds or
to close the CAM SET UP menu and return to normal cam-
Moves the cursor
upwards. Use this button to select an item or adjust the parameters.
adjust the parameters.
parameters of the selected item. The parameter changes each time
this button is pressed.
Moves the cursor to the left. Use this button to select or adjust the
parameters of the selected item. The parameter changes each time
this button is pressed.
Executes selections and displays a submenu for an item with
END: Close Setup menu.
RET: Return to the previous menu.
. The CAM SET UP menu appears.
and
and
or
90°
Diam.120 (Diam.4-3/4)
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
WHITE BAL
END
Left Button
Set Button
, press
for a few seconds. The message ALL
** CAM SET UP **
CAMERA ID
OFF
ALC/ELC
ALC
SHUTTER
OFF
AGC
ON
SENS UP
OFF
WHITE BAL
ATW
END
SET UP DISABLE
83.5 (3-5/16)
2-Diam.5 (2-Diam.3/16)
Unit : mm (inch)
** CAM SET UP **
OFF
ALC
OFF
ON
OFF
ATW
SET UP DISABLE
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
WHITE BAL
END
SET UP ENABLE
Highlighted
Up
Button
Right
Button
Down
Button
mark.
OFF
ALC
OFF
ON
OFF
ATW
Advertisement
Table of Contents
