Care And Cleaning; General Cleaning - Homemaker MH-MF40A User Manual

• Ensure the Variable Mist Control Dial (located on the front of the Mist Generator)
has been set to Maximum (fully clockwise).
• Press the "MIST" button on the fan control panel or remote control.
• At this point, mist will start to be generated.
• When a steady flow of mist is being generated, adjust the Mist rate to your desired
level by rotating the Variable Dial. For less mist, rotate the knob anticlockwise. For
Maximum mist, rotate fully clockwise.
There is an indicator light to show when the Mist Generator has run out of water.
During Normal use and while generating mist, the light will illuminate "Green"
If the Mist Generator runs out of water, this light will illuminate "Red"
Note: Should the light turn Red during use when there is water still in the water tank,
there may be an air lock preventing the water entering the mist generator. If this
should happen, lift the water tank up and down just a little to allow the valve to open
and allow the water to flow.
There could also be mist escaping from the joint between the water tank and mist
generator. This is normal and will stop after a while.

8 Care and Cleaning

8.1 General Cleaning

• Ensure that the fan is switched off from the supply mains before removing the
guard (Grille).
• Unplug the appliance during filling and cleaning.
• To clean the blade and grille assembly, first remove the safety grille, unscrew
the locknut and remove the blade from the Misting Fan. Wipe them clean with a
slightly damp sponge.
• Clean the motor housing and body assembly with a clean, damp cloth and wipe
dry.
• To clean the water tank, rinse out with fresh clean cold water.
Page 18 of 20