4 Instructions For Use
Remove the cable tie and unravel the cordset before operation.
4.1 Head Tilt
The fan and motor assembly Can be tilted up and down to your desired angle.
To adjust the tilt angle, undo the adjustment knob, tilt the head to the desired angle and
then re-tighten the knob. Refer to the section "Attach Head to Stand" for adjustment
instructons.
4.2 Fan On / Off / Speed
Rotate the knob to position I for a low speed , II for a medium speed
and III for a high speed.
Rotate the knob to position 0 to switch the Fan off.
4.3 Oscillation
Press the clutch knob down to activate the oscillating function. The
fan head will swing from side to side whilst blowing air.
To stop oscillation, allow the Fan head to move into the desired
position and then pull the clutch knob up.
4.4 Height Adjustment
The height of the fan can be adjusted. Unscrew the adjustment knob
on the side of the stand post, slide the inner post up or down and then
tighten the knob again to lock in place.
5 Care and Cleaning
•
Turn off and unplug the unit prior to cleaning.
•
To clean the blade and grille assembly, first remove the safety
grille and wipe them clean with a slightly damp sponge.
•
Clean the motor housing and body assembly with a clean, damp cloth and wipe
dry.
•
Never spray with liquids or submerge the Fan in water or any other liquid.
•
Do not use flammable liquids, chemicals, abrasive creams, steel wool or scouring
pads for cleaning.
6 Storage
Switch off and unplug the fan.
Coil the cable loosely. Do not kink or pull the cable tight.
Store your fan in a cool, dry location.
Page 9 of 10