Timer; Using The Misting Generator - Homemaker MH-MF40A User Manual

approximately 30 minutes, the wind pattern will automatically drop down to the
same wind pattern as if Natural Mode was selected at Medium fan speed.
After approximately a further 30 minutes, the wind pattern will automatically drop
down to the same wind pattern as if Natural Mode was selected at low fan speed.
The fan will continue to run in the Low Speed Natural Mode until manually turned
off.
Note: To have the fan automatically turn off at your desired time in this mode, use
the "Timer" function to select the auto off timer.

7.4 Timer

This function sets the duration of operation before the fan automatically turns OFF.
Pressing the Timer button on the fan control panel or the remote control will
increase the time of operation in 0.5 hour increments to a maximum of 7.5 hours.
The total time selected is indicted by the display illuminating at 0.5H, 1H, 0.5 + 1H,
2H, 0.5 + 2H, 1H + 2H, 0.5H + 1H + 2H and so on up until all the lights are
illuminated adding up to 7.5H.
Note: Pressing the button once more after 0.5H + 1H + 2H + 4H is illuminated (at
the same time) will cycle around and cancel the auto off function. (no timer lights
illuminated)
The timer will count down until the time has expired then the fan will turn off
automatically.
To cancel the timer, either press the "OFF" button, which will turn the fan off as
well, or continue to press the "TIMER" button until it cycles back around to where
no timer lights are illuminated.

7.5 Using the Misting generator

Caution:
Be careful when using the fan with the mist function on some types of surfaces as
depending on the environmental conditions (i.e. humid days) the mist may cause
the surface to become wet and slippery. Keep the surface dry at all times to prevent
any injury from slipping over etc.
• To use the Misting Function, ensure the water tank has been filled with fresh clean
water and seated on the mist generator properly.
Ensure the Mist hose connector has been inserted into the top of the water tank.
•
• Ensure the desired Fan speed and mode setting has been selected.
Page 17 of 20