Table of Contents
Advertisement
7.2 Oscillating Function
The fan is fitted with an Oscillating function where when activated, the fan head will
swing from side to side.
•
To activate, the Fan must first be running in Speed Setting LOW, MED or HIGH.
•
Press the "OSC" button on the fan control panel or the remote control once.
The OSC light will illuminate and the fan will start to swing from side to side.
•
To stop the oscillating, press the "OSC" button again.
•
Alternatively, to turn off the oscillating function and the fan, press the "OFF" button.
7.3 Fan Modes
The Fan has three modes being "NOR", "NAT" and "SLEEP"
NOTE: Modes "NAT" and "SLEEP" can only be selected by the remote control by
pressing the "Mode" button.
With the Fan running in "NOR" (Normal) mode, press the "MODE" button on the
remote control and the mode will change to "NAT".
Press the "MODE" button again and the mode will change to "SLEEP" mode.
Press the "MODE" button again, and it will cycle back around to the "NOR" mode.
7.3.1
Normal Mode
"NOR" The Normal Mode is set by default when the unit is first turned on. The wind
remains a constant flow.
7.3.2
Natural Mode
"NAT" The Natural mode creates variable Wind Patterns so as to simulate the
variable winds that you would experience outdoors.
In this mode the speed of the fan continually cycles through a mixed selection of
low, medium, high and off in set intervals.
Depending on which Fan Speed is selected, the wind pattern will be different
7.3.3
Sleep Mode
"SLEEP" The Sleep mode creates wind patterns that are the same as the Natural
Mode wind patterns, however, when the fan is set to either Medium or High Speed,
the pattern will drop a speed level after approximately 30 minutes.
For Example: If High Speed Fan and the Sleep Mode is selected, this will be the
same wind pattern as High Speed setting in Natural Mode. However, after
Page 16 of 20
Hide quick links:
Advertisement
Table of Contents
