Taking Pictures Using Burst Mode - Panasonic DMC-FX2GN Operating Instructions Manual

Taking Pictures using Burst Mode

1 Press the Single/Burst Mode
Button to switch the burst mode
setting and then take pictures.
: High speed
;
: Low speed
;
: No limit
;
No display (cancelled)
Recording pictures (basic)
1600
19
∫ Number of pictures recorded in burst
mode
Burst speed
(pictures/
second)¢
DMC-FX7: DMC-FX7:
3 max. 4
DMC-FX2: DMC-FX2:
4 max. 5
2
Depends on
2 the card
capacity
¢When the shutter speed is higher than
1/60 and the flash is not activated
• In simple mode [
speed is fixed to Low.
• Keep pressing the shutter button fully to
activate the burst mode.
• If the flash is activated, you can record
only 1 picture.
• When the self-timer is used, the number
of recordable pictures in burst mode is
fixed to 3.
• When the burst mode is activated, the
audio recording function on DMC-FX7
cannot be used.
• When setting auto bracket and the burst
mode simultaneously, auto bracket will be
performed by default.
• When the burst mode setting is set to no
limit, the speed of taking pictures becomes
slow during a recording in burst mode.
• Burst mode will not perform as described
if a MultiMediaCard is used in place of an
SD Memory Card. The reading/writing
speed of a MultiMediaCard is slower than
that of an SD Memory Card.
• The setting of auto review function is fixed
to [1SEC.]. (The picture is not enlarged.)
• Burst mode is not cancelled when the
camera is switched off.
Number of recordable
pictures (pictures)
DMC-FX7:
max. 7
DMC-FX2:
max. 10
Depends on
the card
capacity
] (P31), the burst
43