Table of Contents
Advertisement
> Before Start
> Part Names
■ 5. Equalizer Settings
You can adjust the output volume of the range of each connected speaker. You can adjust
the volume of the different sound ranges for each of the speakers. You can set three
different equalizers in Preset 1 to 3. You can select up to 5 bands for the Subwoofer and 15
bands for all other speakers. To use the set equalizer effects, select the preset number in
"Quick Menu"- "AccuEQ" - "Equalizer" (
Front
After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "j6.0 dB" and "i6.0 dB" with
Value is "0.0 dB")
Center
After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "j6.0 dB" and "i6.0 dB" with
Value is "0.0 dB")
Surround
After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "j6.0 dB" and "i6.0 dB" with
Value is "0.0 dB")
Subwoofer
After selecting the speaker frequency from between "25 Hz" and
"160 Hz" with the cursors
frequency between "j6.0 dB" and "i6.0 dB" with
Value is "0.0 dB")
0 This cannot be selected if "No" is set in "Configuration" -
"Subwoofer".
0 The result may not be as expected depending on the input source and listening mode
setting.
> Install
> Initial Setup
P46).
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
> Playback
3. Audio Adjust
■ 1. Multiplex/Mono
Multiplex Input
Set the audio channel or language to be output when playing
Channel
multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed on
the display of this unit when
pressed.
Mono Input Channel
Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
■ 2. Dolby
Loudness
When playing Dolby TrueHD, enable the dialog normalization
Management
function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the Late Night function that allows
you to enjoy surround at low volumes is fixed to off when playing
Dolby Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
Advanced Setup
| Firmware Update | Others
on the remote controller is
53
Hide quick links:
Advertisement
Table of Contents
