Integra DSX-3 Instruction Manual page 51

> Before Start > Part Names
0 Supported sampling rates for PCM signals (stereo, mono) from a digital input are 32kHz,
44.1kHz, 48kHz, 88.2kHz, 96kHz/16bit, 20bit, and 24bit.
■ 4. Analog Audio Input
You can change input assignment between the input selectors and AUDIO IN jacks. If you
do not assign a jack, select "-----".
BD/DVD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
BD/DVD input selector. (Default Value is "AUDIO 1")
CBL/SAT "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CBL/SAT input selector. (Default Value is "AUDIO 2")
GAME "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
GAME input selector. (Default Value is "-----")
STRM BOX "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
STRM BOX input selector. (Default Value is "-----")
CD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CD input selector. (Default Value is "-----")
TV "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
TV input selector. (Default Value is "-----")
PHONO (Default Value is "PHONO") The setting cannot be changed.
> Install > Initial Setup > Playback
2. Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use AccuEQ Room Calibration.
This setting cannot be selected if headphones are connected or audio is output from the
speakers of the TV because "5. Hardware" - "HDMI" - "Audio TV Out" is set to "On".
■ 1. Configuration
Speaker Channels Select "2.1 ch", "3.1 ch", "4.1 ch"or "5.1 ch (Default Value)" to
suit the number of speaker channels connected.
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When subwoofer is connected
"No": When subwoofer is not connected
■ 2. Crossover
Front Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel. (Default Value is
"100Hz")
"Full Band": Full band will be output.
0 If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Full Band" and the low pitched range of the other
channels will be output from the front speakers. Refer to the
instruction manual of your speakers to make the setting.
Center Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel. (Default Value is
"100Hz")
"Full Band": Full band will be output.
0 "Full Band" can be selected only when "Front" is set to "Full
Band".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
Advanced Setup | Firmware Update | Others
51