Raymarine E SERIES Installation Instructions Manual page 47

2. MFD
3. Network connection to MFD (RayNet Radar
cable)
4. Power connection
Note: Open array scanners require a VCM.
RJ45 SeaTalk hs Radar cable connection
To connect a Radar using an RJ45 SeaTalk
cable additional accessories are required.
Radar cable extension
For longer cable runs a Radar power and data digital cable extension is required.
1. Radar extension cable.
2. Radar power and data digital cable.
3. Raymarine ® network switch (or crossover coupler if connecting Radar directly to display).
4. RayNet cable (or RayNet to SeaTalk
Note: The power connection is NOT shown in the diagram. If using an Open Array scanner a VCM
(Voltage Converter Module) must be connected between the scanner and the power supply.
For further information regarding Radar installation (including power connections and mounting), refer to the
installation instructions supplied with the Radar.
Cables and connections
hs Radar
1 2
hs cable, if connecting via a crossover coupler)
1
1. RJ45 SeaTalk hs
2. MFD
3. Network connection to MFD (RayNet to RJ45
SeaTalk hs adaptor cable)
4. SeaTalk hs crossover coupler
3 4
2
4
Radar cable
3
D12884-2
D12254-1
47