Panasonic KX-TG4381NZ Operating Instructions Manual page 25

Feature
Store VM
access#
Time
*7
adjustment
(Caller ID
subscribers only)
V.M. access
For the answering system (KX-TG4391/KX-TG4392)
Feature
Message play
Recording time
Remote code
Ring count
*1 If "System setting" column is checked, you do not need to program the same item
using another handset. (KX-TG4382/KX-TG4392)
*2 If you subscribe to Caller ID service and want to view the caller's information after
lifting up the handset to answer a call, turn off this feature.
*3 Turn this feature off if you prefer not to hear key tones while you are dialling or
pressing any keys, including confirmation tones and error tones.
*4 If you select one of the melody ringer tones, the ringer tone will continue to play for
several seconds even if the caller has already hung up. You may either hear a dial
tone or no one on the line when you answer the call.
*5 Generally, the line mode setting should not be adjusted. If "Line in use" is not
displayed when another phone connected to the same line is in use, you need to
change the line mode to "A".
*6 The recall time depends on your telephone exchange or host PBX. Contact your
PBX supplier if necessary. The setting should stay at "600ms" unless pressing
{RECALL} fails to pick up the waiting call.
*7 This feature allows the unit to automatically adjust the date and time setting when
caller information is received. To use this feature, set the date and time first.
Feature Setting code
code
{3}{3}{1}
{2}{2}{6} {1}: <Caller ID
[auto]>
{0}: Manual
{3}{3}{0}
Feature Setting code
code
{3}{0}{0}
{3}{0}{5} {1}: 1min {2}: 2min
{3}: <3min>
{0}: Greeting only
{3}{0}{6}
<111>
{2}{1}{1} {2}–{7}: 2–7 rings <4>
{0}: Toll saver
System
setting
–
–
System
setting
–
Programming
Page
*1
r
37
r
–
– 37
Page
*1
– 33
r
36
r
34
r
35
25