Yamaha RX-A3000 Owner's Manual page 21

Bi-amp connection
This unit can be connected to speakers that support bi-amp
connections. When connecting speakers, connect the FRONT jacks
and the SURROUND BACK/BI-AMP jacks as in the diagram
below. Configure the bi-amp settings to activate connections.
SPEAKERS
FRONT
SURROUND BACK/
BI-AMP
SINGLE
DOCK NETWORK HDMI RS-232C
1 HDMI OUT 2 AV 1 AV 2 AV 3 AV 4 AV 5 AV 6 AV 7
(1 BD/DVD)
ARC SELECTABLE ARC
AV 1 AV 2 AV 3 AV 4 COMPONENT VIDEO TRIGGER
(1 BD/DVD) AV OUT MON.OUT/ZONE OUT Y P B R P Y AV 3 P B C P R OUT
AV 1
A MONITOR OUT/ZONE OUT REMOTE 1
PHONO Y P P 1 2
GND B R IN OUT IN OUT
AV 2 2
B
AV 4 D +12V 0.1A MAX.
AUDIO 1 AUDIO 2 AUDIO 3 AUDIO 4 MULTI CH INPUT
(2 TV) (3 CD) CENTER ZONE OUT PRE OUT (SINGLE) (FRONT) 1
2
AV OUT/ FRONT SURROUND SUR. BACK SUBWOOFER ZONE 2 ZONE 2 ZONE 3/ ZONE 3/ FRONT/ FRONT/ SURROUND SURROUND SUR. BACK SUR. BACK (REAR) REAR) CENTER CENTER
COAXIAL COAXIAL OPTICAL OPTICAL ZONE 4 OPTICAL COAXIAL R. PRESENCE R. PRESENCE F. PRESENCE F. PRESENCE SUBWOOFER WOOFER
ZONE2/ZONE3/ SURROUND SURROUND BACK/ SURROUND BACK/ SPEAKERS SPEAKERS C CENTER R FRONT FRONT ZONE2/ZONE3/
R.PRESENCE BI-AMP BI-AMP F.PRESENCE
ANTENNA ANTENNA
75 75 FM (4 RADIO) GND AM
EXTRA SP2 SINGLE SINGLE EXTRA SP1 EX
NOTE
Before making bi-amplification connections, remove any
brackets or cables that connect a woofer with a tweeter. Refer to
the instruction manuals of speakers for details. When not
making bi-amplification connections, make sure that the
brackets or cables are connected before connecting the speaker
cables.
J
1 : EXTRA SP1 jacks can be assigned to Zone3 and EXTRA SP2 jacks can be
assigned to Zone2 by using "Power Amp Assign" (
J
2 :
Refer to the "Extended functionality that can be configured as needed
(Advanced Setup menu)" ( p. 125) for details on the Advanced Setup menu.
Multi-zone audio system using the internal
amplifier of this unit
Connect the speakers in the second zone and the third zone to the
EXTRA SP1/EXTRA SP2 jacks as in the diagram below.
Zone3
ZONE2/ZONE3/
ZONE2/ZONE3/
F.PRESENCE
R.PRESENCE
EXTRA SP2
AC IN
CAUTION
The EXTRA SP jacks of this unit should not be connected to a
Passive Loudspeaker Selector Box or more than one loudspeaker
per channel.
Connection to a Passive Loudspeaker Selector Box or multiple
speakers per channel could create an abnormally low impedance
load resulting in amplifier damage. See this owner's manual for
correct usage.
Compliance with minimum speaker impedance information for all
channels must be maintained at all times. This information is found
on the back panel of this unit.
p. 97).
J1 J1
Zone2
ZONE2/ZONE3/
F.PRESENCE
EXTRA SP1
DOCK NETWORK HDMI RS-232C
HDMI OUT
1 2 AV 1 AV 2 AV 3 AV 4 AV 5 AV 6 AV 7
ARC SELECTABLE ARC (1 BD/DVD)
(1 BD/DVD) AV 1 AV 2 AV 3 AV 4 AV OUT MON.OUT/ZONE OUT Y P COMPONENT VIDEO P Y P P TRIGGER OUT
B R AV 3 B C R
AV 1 1
PHONO A MONITOR OUT/ZONE OUT 1 REMOTE 2
GND Y P B R P IN OUT IN OUT
AV 2 B 2
AV 4 D +12V 0.1A MAX.
(2 TV) AUDIO 1 (3 CD) AUDIO 2 AUDIO 3 AUDIO 4 MULTI CH INPUT CENTER ZONE OUT PRE OUT (SINGLE) (FRONT) 1
2
ZONE 3/ FRONT/ (REAR)
COAXIAL COAXIAL OPTICAL OPTICAL AV OUT/ ZONE 4 OPTICAL COAXIAL COAXIAL FRONT FRONT SURROUND SURROUND SUR. BACK SUBWOOFER ZONE 2 R. PRESENCE F. PRESENCE SURROUND SUR. BACK SUBWOOFER CENTER
SPEAKERS AC IN A
ZONE2/ZONE3/ ZONE2/ZONE3/ R.PRESENCE R.PRESENCE SURROUND SURROUND BACK/ BI-AMP CENTER FRONT ZONE2/ZONE3/ ZONE2/ZONE3/ F.PRESENCE F.PRESENCE
ANTENNA ANTENNA
FM (4 RADIO) GND AM
75 75
EXTRA SP2 EXTRA SP2 SINGLE EXTRA SP1 EXTRA SP1
CONNECTIONS
Connecting speakers
Changing speaker impedance
This unit is configured for 8 Ω speakers at factory setting.
When connecting to 6 Ω speakers, carry out the following
procedure to switch to 6 Ω. When this unit is configured for 6 Ω
speakers, 4 Ω speakers can also be used as the front speakers.
Switch this unit to the standby mode.
1
Press MAIN ZONE A while pressing and holding
2
STRAIGHT on the front panel.
Release the keys when "ADVANCED SETUP" is displayed on
the front panel display.
After approximately a few seconds, the top menu item is
J2
displayed.
MAIN ZONE A
STRAIGHT
Continues to the
next page
21
En