Yamaha RX-A3000 Owner's Manual page 110

SOURCE RECEIVER
Entering standby mode
automatically when no operations
are performed
AV
1 2 3 4
5 6 7 V-AUX
Auto Power Down
AUDIO
1 2 3 4
If you do not operate this unit or use the remote control
PHONO MULTI USB NET
for an extended period of time, it will automatically go
DOCK TUNER
[ A ] [ B ]
into standby mode (Auto Power Down function). This
function's default setting is "Off." When you want to
enable this function, set the amount of time to pass
before this unit will enter standby.
4Hours
8Hours
i
ENTER
12Hours
RETURN
Off (Default)
This unit starts a countdown of 30 seconds before
entering the standby mode. Pressing any key of the
remote control during the countdown cancels entering
the standby mode and reset the timer.
Input Assignment
Assigns the coaxial or optical input jack(s) to the
selected input source when this unit's initial settings do
not correspond to your needs. Change the parameter to
reassign the respective jacks and effectively connect
more components.
Once the input jacks are reassigned, the corresponding
component can be selected using the Input selector
buttons.
Goes into standby mode, when you have
Example: Assigning the OPTICAL input jack to
not operated this unit for four hours.
"AV1."
Goes into standby mode, when you have
not operated this unit for eight hours.
Goes into standby mode, when you have
1
not operated this unit for twelve hours.
Auto Power Down function is disabled.
2
Assigning component input and
output jacks
iENTER
Press to display the "Input
Assignment" screen.
iCursor B / C / D / E
Press to select the
cell at the intersection with the "AV1" and
"Coax/Opt" and then press iENTER.
SETUP
Setting various functions (Setup menu)
iCursor D / E
3 Press to select "c" and then
press iENTER.
Select "None" to clear the existing assignment.
The choices indicate the following jacks.
a, b, f
: COAXIAL jacks
c, d, e
: OPTICAL jacks
, , , : COMPONENT VIDEO jacks
The choices indicate the jacks marked the same
alphanumeric on the rear of this unit. For details on
marks on the rear of this unit, refer to "Rear panel"
( p. 10).
iRETURN
4 Press to apply change and
return to the previous screen.
• A specific item cannot be selected more than once for
the same type of jack.
• Only component, coaxial and optical jacks can be
reassigned.
• Coaxial and optical jacks cannot be assigned to the
input at the same time.
En
110