Software Installation; Engineering Setups - Sony CCP-8000 System Setup Manual

3-4. Ethernet Switch Settings

3-5. Software Installation

3-6. Engineering Setups

Step 4 : Disable Spanning-Tree
Disable all spanning tree on VLAN.
Refer to Catalyst 4000/5000 Family Software Configuration Guide
Step 5 : Assign sc0 to VLAN
Assign sc0 to VLAN except Control LAN, Data LAN, and Peripheral LAN.
Refer to Catalyst 4000/5000 Family Software Configuration Guide
Step 6 : Disable Cisco Discovery Protocol (CDP)
Disable CDP globally.
Refer to Catalyst 4000/5000 Family Software Configuration Guide
3-5. Software Installation
The current software version is displayed by pressing the following buttons in order.
"ENG SETUP"→"System"→"Install" to show the Install menu.
Select the desired software to install on the Install menu and press the Install button. Then installation
starts.
The status area displays the device ID of each device, and the version, and released date.
3-6. Engineering Setups
The engineering setups are required to configure the system connected to switcher, DME, control panel,
DCU and external devices.
The "ENG SETUP" of menu panel GUI provides you the following items can be set.
. Recognizing devices on the LAN
. Switching the signal format
. Switching the screen aspect ratio
. Selecting the state after powering on
. Time setting
. Signal assignment to cross-point buttons
. Output signal assignment
For detail setup of ENG SETUP, refer to User's Guide Volume 1 Chapter 1 "Setup" and User's Guide
Volume 2 Chapter 17 "Engineering Setup".
3-9
MVS-8000 System
SYSTEM SETUP