Sony CCP-8000 System Setup Manual page 42

2-4. CCP-8000 Installation
Rack Mounting the MKS-8075 (Extension
Adaptor)/MKS-8076 (Memory Card/USB Adaptor)
The MKS-8075 and MKS-8076 can be mounted in the 19-
inch standard rack.
To mount them in the rack, use the recommended rack
mount parts and follow the procedure described below.
n
In order to rack mount the MKS-8075 and MKS-8076, the
following conditions must be met.
. The two or more adaptors must be configured to the two
rows as shown in the illustration by connecting them
horizontally together.
. Number of adaptors connected must be either 2 or 4 or 6
or 8.
. The connection method C (flat) must be used.
. For the connection method, refer to "2-8-1. Connecting
the MKS-8075/MKS-8076".
Tools required
. Screws (RK5 x 16) for rack mounting
. Ornamental washer for rack mount
(Sony part No.: 2-297-913-01)
When 2 adaptors are connected : Each 4 pcs
When 4 adaptors are connected : Each 8 pcs
When 6 adaptors are connected : Each 12 pcs
When 8 adaptors are connected : Each 16 pcs
1. Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolt or others.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the side panels of the adaptor itself for
rack mount.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
side panels and fix the unit in the rack.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Mount in the rack in a stable position.
2-12
2. Rack mounting procedure
(1) Install the adaptor to the rack using rack mounting
screws (RK5 x 16) and washers as shown in the
illustration.
(The illustration below shows the configuration when
8 adaptors are connected.)
RK5 x 16
Washer
Washer
RK5 x 16
MVS-8000 System
SYSTEM SETUP