To Disconnect Usb Cable Safely; If You No Longer Need Software Or Driver (Uninstall) - Panasonic PV-GS400 Operating Instructions Manual

7
Double click [PhotoImpression Installer] (or
[PhotoBase Installer] or
[PanoramaMaker Installer] or
[PhotoPrinter Installer]).
8
Follow the instructions on the computer
screen until the installation is complete.
ª To start software in ArcSoft Software
Suite
1
Select [Start] >> [All Programs (Programs)]
>> [ArcSoft Software Suite] >>
[Panorama Maker 3] (or [PhotoBase 4] or
[PhotoImpression 4] or [PhotoPrinter 4]).
For Information on ArcSoft Software:
TEL: 1-510-440-9901
Website: www.arcsoft.com
Refer to Help information about application
operations and other Error messages.

To disconnect USB Cable safely

If USB Cable is disconnected while computer is
on, error dialog box may appear. In such a case
click [OK] and close the dialog box. By following
the steps below you can disconnect the cable
safely.
1
Double click the
≥Hardware disconnect dialog box appears.
2
Select [USB Mass Storage Device] and click
[Stop].
3
Verify [Matshita DVC USB Device] is
selected and click [OK].
≥You can safely disconnect the cable.
68
With a PC
icon in task tray.
Note on the driver name displayed
The driver name displayed will differ depending
on your OS, operating environment and the mode
of the Camcorder.
≥Some Operating Systems, such as Windows
98SE, may not show the icon indicating that you
may safely disconnect in task tray. (OS may be
set not to show.) Make sure Camcorder's Card
Access Lamp is off and disconnect the cable.
Also, with Windows Me, the icon will not be
displayed when in Tape Recording Mode or
Tape Playback Mode.
CAUTION:
If you disconnect the USB Cable while the
Card Access Lamp is on, it may damage the
Card data.
If the above operation is not performed correctly,
when data is copied from the personal computer
to an SD Memory Card, the copied data may be
damaged.
When the following operations are performed, the
same results will occur as when the USB Cable is
incorrectly removed (above). Therefore, it is
imperative that the above operation is completed
before proceeding.
≥When SD Memory Card is removed.
≥When Camcorder power is turned OFF.
≥When Mode Dial
(44)
modes.
(44)
If you no longer need software or
driver (Uninstall)
The screens may vary with the type of OS.
1
Select [Start] (>> [Settings]) >>
[Control Panel], select the software or the
driver from [Add/Remove Programs] to
uninstall.
≥Uninstalling steps may vary depending on the
OS. Please refer to the user manual of your OS.
ON
is turned to change