Warning/Alarm Indicators - Panasonic PV-GS400 Operating Instructions Manual

Warning/Alarm Indicators

If any one of the following indicators lights up or
flashes, please check the condition of the
Camcorder.
3DEW (DEW DETECT/EJECT TAPE):
Condensation has occurred.
Y (CHECK REC TAB):
The accidental erasure prevention switch on
the inserted Cassette is open (that is, set to
[SAVE]).
You are attempting Audio dubbing or Digital
dubbing on a Tape while setting the
accidental erasure prevention switch to
[SAVE].
Y (TAPE NOT INSERTED):
No Cassette in inserted.
6 (LOW BATTERY):
The Battery is low. Recharge it.
0: The built-in battery is low.
: (NEED HEAD CLEANING):
The video heads are dirty.
2END (TAPE END):
The Tape came to an end during recording.
REMOTE (CHECK REMOTE MODE):
Wrong Remote Controller Mode has been
selected.
-16-
UNPLAYABLE TAPE
(OTHER FORMAT):
You are attempting to play back a tape
section that has been recorded with a
different TV system.
UNABLE TO A.DUB
(LP RECORDED):
Because the original recording was done in
LP Mode, audio dubbing cannot be
performed.
INCOMPATIBLE TAPE:
This cassette is incompatible.
PUSH THE RESET SWITCH:
Irregular mechanism is detected. Use
projection on the Lens Cap to press the
[RESET] Button (
problem.
CARD FULL:
Card does not have sufficient memory
remaining.
Select Picture Playback Mode and delete
unnecessary files.
NO CARD:
Card is not inserted.
NO DATA:
There are no recorded files on the Card.
UNPLAYABLE CARD:
You are attempting to play back data which
is not compatible with this Camcorder.
-83-
-18-
-16-
-26-
-83-
). This may solve the
-13-
Others
CARD ERROR:
The Card is not compatible with this
Camcorder.
COPY INHIBITED:
Because the media is protected by a copy
guard, images cannot be recorded correctly.
CANNOT USE USB
CHANGE MODE:
The USB Cable is connected to the
Camcorder in Card Recording Mode.
CANNOT OPERATE:
You are attempting to turn the Camcorder
off while connecting the USB Cable to the
Camcorder.
You are attempting to record pictures on a
Card while connecting the USB Cable to the
Camcorder in Tape Recording/Playback
Mode.
UNABLE TO WRITE
(MULTI RECORDING):
The [PHOTO SHOT] Button is pressed
when you are recording pictures on a Tape
while setting the Digital Effect [MULTI] of
[EFFECT1].
UNABLE TO WRITE:
The [PHOTO SHOT] Button is pressed
when you are recording on a Tape and
while inserting a Title.
NO TITLE:
Titles are not recorded.
UNABLE TO INSERT TITLE:
You are attempting to perform Title In
Function when RapidFire Consecutive
Photoshot function is set.
UNABLE TO WRITE
(WIDE MODE):
You are attempting to record S1 signal
pictures (with aspect ratio 16:9) by pressing
the [PHOTO SHOT] Button.
FILE LOCKED:
You are attempting to erase protected files.
CARD LOCKED:
The write protection switch on the SD
Memory Card is set to [LOCK].
DISCONNECT USB CABLE:
You are attempting to turn the Mode Dial in
PC Mode while connecting the USB Cable
to the Camcorder.
PC DOES NOT SUPPORT USB2.0:
In the MotionDV STUDIO Mode, your
personal computer does not support USB
2.0 Hi-Speed.
CAN NOT USE USB:
You are attempting to connect the USB
Cable while the DV Cable is connected.
73