To Disconnect Usb Cable Safely; Verifying The Unit Is Correctly Recognized By The Computer - Panasonic VDRD310EP Operating Instructions Manual

LSQT1140_EN.book 16 ページ ２００６年１２月７日 木曜日 午後７時４５分
Installation/Connection
Example folder structure of a DVD-RW (Video
format) or DVD-R:
DVD_CAMERA*
VIDEO_TS
≥ DVD-Video format motion pictures are stored
in the [VIDEO_TS] folder.
* Depending on the maker of the disc and the
device used to format it, the name displayed
will differ.
Do not move or change the name of the
folders and files recorded on this unit by
Windows Explorer etc.
∫ When accessing the card
[Removable Disk] is displayed in [My Computer].
Example folder structure of an SD card:
Removable Disk
DCIM
MISC
≥ JPEG format still pictures (IMGA0001.JPG
etc.) are stored in the [100CDPFP] folder.
These can be opened with picture software
that supports JPEG pictures.
≥ Up to 999 files can be recorded in the
[100CDPFP] or other such folder.
≥ The DPOF setting files are recorded in the
[MISC] folder.
≥ Do not use the computer to delete the SD
card's folders. Otherwise, it may no longer be
possible for this unit to read the SD card.
≥ Always use this unit to format SD cards.
≥ When data not supported by this unit has been
recorded on a computer, it will not be
recognized by this unit.
16
LSQT1140
100CDPFP
To disconnect USB cable
safely
1
Double click the
tray.
Hardware disconnect dialogue appears.
≥ Depending on your computer's settings, this
icon may not be displayed.
2
Select [USB Mass Storage
Device] and click [Stop].
3
Verify [MATSHITA DVD-RAM
LMXK1987 USB Device] or
[MATSHITA DVD Cam USB
Device] is selected and click
[OK].
Click [Close], and you can safely disconnect the
cable.
≥ If you disconnect the USB cable while the
access lamp is on or while
LCD monitor, it may freeze the software or
damage the data. (Refer to the operating
instructions for DVD Video Camera.)
Verifying the unit is
correctly recognized by the
computer
To verify the unit is correctly recognized by the
computer, select the unit's mode, connect the
unit to the computer via the USB cable and then
follow the steps below.
≥ With some computers including those made by
NEC, the Device Manager may not be
displayed if a mode that places restrictions on
the functions has been established. Consult
the manufacturer or follow the steps in your
computer's operating instructions to establish a
mode in which all the functions can be used,
then proceed with operation.
icon in task
appears on the