Panasonic KX-TVP50 Getting Started page 8

Procedure - Part 1 (basic installation)
number is 203; etc. (There is no mailbox 207 and perhaps no mailbox 208.)
Restore the DIP switch to position 0
9.
Check the system:
10.
You should hear:
If you do not hear this, something is wrong. Try again from (II) Step 1.
(III) Select System/User 1/User 2 Prompts
Please see Procedure – Part 3 (Step 3)
1.
and decide what prompts you want to use. Then follow the steps below.
Power off the VPS.
2.
3. If you want to
(see FIG.2).
If you want to
(see FIG.2).
If you want to
(see FIG.2).
Power on the VPS
4.
Restore the DIP switch to position 0
5.
The prompts you want will be activated
6.
7. This completes "basic installation". Proceed to Procedure – Part 2.
8
Procedure – Part 1 (basic installation)
Pick up Extn. 201 and call the VPS (Extn. 207).
You have zero new messages.
To receive the message, press 1.
To deliver a message, press 2.
To check the mailbox distribution, press 3.
For automated attendant status, press 4.
For mailbox management, press 5.
For other features, press 6.
To end this call, press .
use System Prompts, set the DIP switch to position 12
use User 1 Prompts, set the DIP switch to position 13
use User 2 Prompts, set the DIP switch to position 14
and wait about 3.5 min.
(see FIG.2).
for a brief explanation of VPS voice prompts
(see FIG.2).
.
Confirm this by calling the system.