Panasonic KX-TVP50 Getting Started page 7

Procedure – Part 1 (basic installation)
From the APT, use System Program [130]
4.
to enable APT integration
instructions in the PBX Installation Manual. If System Program [130] does not appear, then
your PBX has old software — APT integration is not possible; you need to upgrade your PBX
software; please contact your dealer or service centre.
5. FOR IMMEDIATE VPS RESPONSE FOR INCOMING CALLS, PROGRAM THE PBX AS
FOLLOWS:
System Program [414]-[416] "Exchange Line Mode –Day/Night/Lunch"
In this case, calls from the outside will go directly to the VPS and the VPS will respond quickly.
FOR OPERATOR BACKUP MODE FOR INCOMING CALLS, PROGRAM THE PBX AS
FOLLOWS:
System Program [414]-[416] – Normal
System Program [408]-[410] "Flexible Ringing Assignment –Day/Night/Lunch"
System Program [411]-[413] "Delayed Ringing Assignment –Day/Night/Lunch"
In this situation, the operator extensions will ring. If it is not answered by the delay time, the
VPS will take the call.
Exit System Programming.
6.
(II) Set up a mailbox for each subscriber of the VPS
Put the VPS DIP switch in position 5
1.
powering up) will completely reset the VPS — all messages, all data, and all parameters will
be cleared.
Be sure this is OK to do!
Note
• The system clock will not be affected and also User 1 and User 2 Prompts will not be
erased.
Plug in the power to the VPS
2.
3. After about 1.5 min, the power LED will start to flash.
4. After about 2 min, the flashing should stop and the LED should stay fully lit. This completes
system reset.
If the LED continues to flash, something is wrong. Check all your cables (see FIG.1 again as
well); power off and on the PBX; and start again from (II) Step 1.
Power off the VPS.
5.
set all VPS ports for AA Service
6. If you want to
switch in position 10
Service
(described on page 5),
Power on the VPS
7.
8. This completes the creation of a mailbox for each extension.
Extn. 201's mailbox number is 201; Extn. 202's mailbox number is 202; Extn. 203's mailbox
on PBX jack(s) (JACK 07 or JACKs 07 & 08). Follow the
–DIL on the VPS jack(s) (JACK 07, or JACKs 07 & 08)
–specify the operator extension jack
–put 5 s/10 s/15 s delay on the VPS jack(s) (JACK 07, or JACKs
07 & 08)
.
The power LED should be on.
(see FIG.2). If you want to
put the DIP switch in position 11
and wait about 3.5 min.
"Voice Mail 1 APT Port for KX-TVP50"
(see FIG.2 on page 15). This setting (after
(described on page 5),
set all VPS ports for VM
Procedure – Part 1 (basic installation)
put the DIP
(see FIG.2).
7