Diagnostics - Golden Technologies Golden Avenger GA 541 Owner's Manual

Avenger Owner's Manual
TruCharge Battery Display Diagnostics
be charged before driving your Avenger.™
Fault
Description
Type
1 Reaching low voltage
2 Motor disconnected
3 Motor wiring fault
4 Parking brake off
5 Not used
6 Inhibit active
Throttle potentiometer
7
fault
8 Possible controller fault
9 Solenoid brake fault
10 High battery voltage
NEARLY DISCHARGED. FAILURE TO COMPLY WITH THIS CONDITION MAY
LEAVE THE USER STRANDED IN AN UNSAFE POSITION.
X. DIAGNOSTICS SYSTEM
When the display is down to two (2) bars, the batteries must
Bars
The battery needs charging or there is a bad
connection to the battery. Check all connections
1 bar
between the controller and the battery. If the
connections are good, try charging the battery.
There is a bad connection to the motor. Check all
of the connections between the motor and the
2 bars
controller.
The motor has a short circuit to a battery
3 bars
connection. Contact your service agent.
The freewheel switch or manual brake
disengagement mechanism is operated. Check the
4 bars
position of the switch or lever.
Not used.
5 bars
The controller is being inhibited from driving; this
may be caused because the battery charge is still
6 bars
connected or the seat is not in the proper driving
position.
A throttle fault is indicated. Make sure the throttle is
7 bars
in the rest position before switching on the scooter.
A controller fault has been indicated. Contact
8 bars
your service agent.
There is a bad connection to the parking brake.
Check all connections between the parking brake
9 bars
and the controller.
An excessive voltage has been applied to the
controller. This is usually caused by a poor
10 bars
battery connection. Check all connections
between the battery and controller.
DO NOT OPERATE THE SCOOTER IF THE BATTERY IS
29
Revised 10/27/14
Self Help Guide