Diagnostics - Golden Technologies ALERO GP52 Owner's Manual

Golden Alero GP52SS Owner's Manual
The PG VSI controller on your Alero will provide you with information should a
malfunction happen with your power chair. The LED lights on the controller will flash in a
certain sequence to inform you of a malfunction. If more than one fault exists, then the
fault having the highest priority is indicated. All faults disable the controller and require
the controller to be turned off then on again if the source of the fault is removed.
One Bar
Two Bars
Three Bars
Four Bars
Five Bars
Six Bars
Seven Bars
Eight Bars
Nine Bars
Ten Bars
Note: If you detect there are problems with the motors, the battery charger, the
controller or damage to the power wheelchair frame, it is highly recommended
you contact your local Authorized Golden Dealer.

DIAGNOSTICS

The batteries need charging or there is a bad connection to the
batteries. Check the connection to the batteries. If the
connections are good, charge the batteries.
The left side motor has a bad connection. Check the
connections to the left side motor. If the connections are good,
call your Golden Authorized Dealer for service.
The left side motor has a short circuit to a battery connection.
Call your Golden Authorized Dealer for service.
The right side motor has a bad connection. Check the
connections to the right side motor. If the connections are
good, call your Golden Authorized Dealer for service.
The right side motor has a short circuit to a battery connection.
Call your Golden Authorized Dealer for service.
The wheelchair is being prevented from driving by an external
signal. The exact cause will depend on the type of wheelchair
you have; one possibility is the battery charger is connected
A joystick fault is indicated. Make sure the joystick is in the
center position before switching on the control system.
A control system fault is indicated. Make sure all connections
are secure.
The parking brakes have a bad connection. Check the parking
brake and motor connections. Make sure the control system
connections are secure.
An excessive voltage has been applied to the control system.
This is usually caused by a poor battery connection. Check
battery connections.
25
Revised 0807