Care And Maintenance; Main Circuit Breaker - Golden Technologies Golden Avenger GA 541 Owner's Manual

Avenger Owner's Manual
XI. CARE AND MAINTENANCE

Main Circuit Breaker

The 50-amp circuit breaker and exposed reset button
are located under the battery cover. The button is visible
through the battery cover. If your Avenger™ fails to
operate, your main circuit breaker may have tripped.
DO NOT ATTEMPT ELECTRICAL
REPAIRS. CONSULT GOLDEN TECHNOLOGIES OR YOUR
AUTHORIZED GOLDEN DEALER.
Possible causes for the main circuit breaker to trip:
• "Run-down" batteries.
• Over exerting the motor.
Possible solutions:
• Recharge your batteries.
• If the problem persists, have an authorized Golden dealer "load test" the
batteries to verify they are not damaged.
• If the problem persists, assure your battery charger is operating properly.
Resetting the Main Circuit Breaker
If the main circuit breaker trips as a result of "run-down" batteries or because of a
temporary overload, reset the circuit breaker using the following directions:
1. Wait 5 minutes to allow the motor and electronics board to cool, or return
to "normal" operating temperature.
2. Press in on the main circuit breaker reset button.
BE SURE YOU REMOVE THE KEY FROM THE KEY RECEPTACLE
BEFORE RESETTING YOUR SCOOTER.
If the main circuit breaker continues to trip, there is an underlying
electrical fault that needs professional attention. Please contact your local Golden
Technologies Dealer.
Do not reset your main circuit breaker repeatedly. You must correct the
underlying problem. Failure to correct the problem could cause injury or damage and
will void the warranty.
This is the "LED" light that will flash
in the event of a problem.
30
Revised 10/27/14
Circuit Breaker
Found on the rear
of the unit next to
the freewheel
brake release.