Paging/Intercom; Answering A Call - Grandstream Networks GVC3200 User Manual


Both GVC3200/GVC3202 and VoIP phone are under the same LAN / VPN using private or public IP
addresses
Or

NAT is disabled or GVC3200/GVC3202 NAT is disabled.
Both devices can be connected through a router using public or private IP addresses (with necessary port
forwarding or DMZ).
To make a direct IP call, please follow the steps below:
1. Access the dial screen on GVC3200/GVC3202 LCD.
2. Press the red shortcut key on the remote control to bring up call mode setting screen, set the mode to
"IP Call". This step is optional.
3. Input the target IP address. For example, if the target IP address is 192.168.124.123 and the port is
5062, input the following:
192*168*124*123#5062
The * key represents the dot (.) and the # key represents the colon (:).
4. Press the yellow shortcut key on the remote control to select "Audio Call" or "Video Call".
on the remote control to dial out.
5. Press

Paging/Intercom

Before placing paging/intercom, please make sure the callee has paging/intercom enabled so that it can
answer the paging/intercom call automatically. To make paging/intercom call:
Access the dial screen on GVC3200/GVC3202.
1.
Press the red shortcut key on the remote control to bring up call mode setting screen, set the mode to
2.
"Paging/Intercom".
Enter the number to dial.
3.
Press the yellow shortcut key on the remote control to select "Audio Call" or "Video Call".
4.
Press on the remote control to dial out.
5.

Answering a Call

When the device is in idle and there is an incoming video call made by SIP or IPVideoTalk account, the
device will show the call screen as below:
GVC3200/GVC3202 User Guide
P a g e | 58