Aircraft Installation; Child Placement In Restraint - Baby Trend CV88C Owner's Manual

5.0 Installation and Use
10. Raise Forward Lock-off over the LATCH
belt. Engage the lock tab and press down to
lock (Fig. 41a).
11. Lower flap and secure hook and loop
fasteners (Fig. 41b).

5.9 Aircraft installation

1. Follow the vehicle lap/shoulder belt
installation for use in an Aircraft.
2. Consult your airline for requirements to use
this restraint.

5.10 Child Placement in Restraint

1. Place child in the restraint with the child's
back flat against the back of the restraint and
the child's bottom touching the seat (Fig 41c).
41
Fig. 41a
Fig. 41b
Fig. 41c
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use
2. Rear Facing - Harness Strap should be
located in the nearest position at or below the
shoulder (Fig. 42a).
Forward Facing - Harness Strap Height
should be located in the slot at or slightly
above the child's shoulder (Fig. 42b).
Note: Forward facing occupants weighing
more than 32 lbs (14.5kg) or are 35 in. tall
(88.9 cm) MUST use height position 4.
Then place harness straps over the child's
shoulders (Fig. 42c).
Note: Check the height of the harness straps
are just above the child's shoulders.
3. The Convertible has been safety tested with
the height insert and head pillow (Fig. 42d)
that are included with this restraint. The height
insert is needed until the child's shoulder is at
or above position 1. Do not use height insert
with a child weighing more than 18 lbs.
4. Insert the buckle tongues into the buckle
(Fig. 42e).
Note: Pull up and test buckle tongues to be
sure they are secure.
5. Place chest clip at arm pit level (Fig. 42f). Insert
chest clip tabs and press together. Pull outward
on chest clip's ends to be sure it is secure.
Copyright © 2016, Baby Trend, Inc.
Fig. 42a
Fig. 42b
Fig. 42c
Fig. 42d
Fig. 42e
Fig. 42f
42