Installation And Use; Child Placement In Restraint - Baby Trend CV88C Owner's Manual

5.0 Installation and Use

WARNING!
DEATH or SERIOUS INJURY can occur:
• Use only in a rear facing position when using restraint with an
infant weighing less than 22 lbs. (9 kg).
• Use only with children who weigh between 5 - 65 lbs. (2.3 - 29
kg) and whose height is 50 inches (127 cm) or less. Rear Facing
with the removable upper seatback removed; 5 - 22 pounds. Rear
facing with removable upper seatback installed; 5 - 40 lbs. (2.3-
18.1 kg). Forward facing 1 year and 23 - 65 lbs. (10.43 - 29 kg).
• Snugly adjust the belts (Harness) provided with this child
restraint around your child. Snug means you can not pinch
webbing once buckled.
• Secure the top anchorage strap provided with this restraint.
• Secure this child restraint with the vehicle's child restraint
Anchorage system (LATCH) if available or with a lap/shoulder
belt.
• Follow all instructions on this child restraint and in the written
Instructions located on the back of the seat. Do not use without
instructions. Call 1-800-328-7363 to obtain instructions.
• Use vehicle lap/shoulder belt (not LATCH) for children weighing
more than 45 lbs (20.5 kg).
• Register your child restraint with Baby Trend.
• DO NOT place this rear facing child seat in a front seat that has
an active airbag.
• NEVER leave child unattended under any circumstance.
15
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use
Routing paths for forward facing installation
Lap belt with Lap/Shoulder belt
top tether with top tether

5.1 Child Placement in Restraint

1. Place child in the restraint with the child's back flat against the back
of the restraint and the child's bottom touching the seat.
2. Place harness straps over the child's shoulders.
Note: Check the height of the harness straps at the child's shoulders.
3. Place 5-point crotch buckle in rear position for rear facing and outer
position for forward facing.
4. Insert the buckle tongues into the buckle.
buckle tongues to be sure they are secure.
5. Place chest clip at arm pit level. Insert chest clip tabs and press
together. Pull outward on chest clip's ends to be sure it is secure.
6. Pull on harness adjuster to tighten harness straps. A snug strap
should not allow any slack. It lies in a relatively straight line without
sagging. It does not press on to the child's skin or push the child's
body into an unnatural position.
Copyright © 2016, Baby Trend, Inc.
LATCH Lower anchor
with top tether
Note: Pull up and test
16