Table of Contents
Advertisement
5.0 Installation and Use
2. Lift back flap and place harness to side
(Fig 35a).
3. Route LATCH belt through the front facing
safety belt path (Fig. 35b) leaving the
adjuster side of the LATCH belt on the
child's RIGHT side (Fig. 35c).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing
the restraint to the vehicle.
4. Lower flap and secure hook and loop
fasteners (Fig. 35d).
5.9 Aircraft installation
1. Follow the seat belt installation for use in an
Aircraft.
2. Consult your airline for requirements to use this
restraint.
35
Fig. 35a
Fig. 35b
Fig. 35c
Fig. 35d
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use
5.10 Child Placement in Restraint
1. Place child in the restraint with the child's
back flat against the back of the restraint and
the child's bottom touching the seat (Fig 36a).
2. Rear Facing - Harness Strap should be
located in the nearest position at or below the
shoulder (Fig. 36b).
Forward Facing - Harness Strap Height
should be located in the slot at or slightly
above the child's shoulder (Fig. 36c).
Note: Forward facing occupants weighing
more than 32 lbs (14.5kg) or are 35 in. tall
(88.9 cm) MUST use height postion 4.
Then place harness straps over the child's
shoulders (Fig. 36d).
Note: Check the height of the harness straps
are just above the child's shoulders.
3. The Convertable has been safety tested
with the height insert and head pillow (Fig.
36e) that are included with this restraint.
The height insert is needed until the child's
shoulder is at or above position 1.
Copyright © 2016, Baby Trend, Inc.
Fig. 36a
Fig. 36b
Fig. 36c
Fig. 36d
Fig. 36e
36
Advertisement
Table of Contents
