Konica Minolta bizhub 162 Installation Manual page 6

1 2
1 2
3
4034IXE017DA Setting --- 12 Setting --- 23
4980U036AB
Type Jumper
1 2 3 4 5
STD(110V)UL
23 12 12 12 23 23
STD(220V)
TBR-21 23 23 23 23 12 12 Finland, Iceland, Licehtenstein, Luxembourg,
Australia 23 23 12 12 23 23 Australia, South Africa, Korea
S.Africa
Korea
China 23 12 12 12 23 12 China
4398IXC005DA
8. Set the jumpers (JP1 to JP6) on the NCU
3
Board according to the applicable marketing
area.
* Refer to the jumper setting list by country
given below for the corresponding setting
positions according to the country.
Marketing area
6
U.S.A., Canada, Taiwan, U.A.E., South America
Singapore, Malaysia, Hong Kong, Russia, Iran,
Bahrain, Qatar, Poland, Croatia, Slovenia, Baltic,
Romania, Ukraine, Kuwait, New Zealand,
Philippine, U.A.E., Other 220V Countries
Czech, Norway, Sweden, Belgium, Cyprus,
Denmark, Hungary, France, Greece, Ireland, Italy,
Netherlands, Turkey, Switzerland, Germany, U.K.,
Austria, Portugal, Spain
9. Fit the TEL/LINE line connectors of the NCU
Board into the holes in the machine frame
and connect the NCU Board to the hookup
connector of the Fax Board.
NOTE
When performing this procedure, make
sure that the connector pins on the
backside of the NCU Board are properly
aligned with the mating holes.
FK-505
4398IXC006DA
4398U013AA
4398IXC007DA
4398IXC008DA
– 5 –
10. Secure the NCU Board using the four
Screws furnished with the kit.
11. Secure the ground terminal of the NCU
Board. (one screw)
12. Connect the Image Controller Board.
13. Secure the Image Controller Board using
four screws.