Konica Minolta bizhub 162 Installation Manual page 4

4398U011AD
4398U012AB
4398U013AA
4398U015AA
7. Fit the TEL/LINE line connectors of the NCU
Board into the holes in the machine frame
and connect the NCU Board to the hookup
connector of the Fax Board.
NOTE
When performing this procedure, make
sure that the connector pins on the
backside of the NCU Board are properly
aligned with the mating holes.
8. Secure the NCU Board using the four
Screws furnished with the kit.
9. Secure the ground terminal of the NCU
Board. (one screw)
10. Install the Speaker & Battery Assy.
(two screws)
FK-505
4398U016AA
4048U006AB
– 3 –
11. Connect the speaker and battery connectors
to the Fax Board.
• Plug the battery connector into the upper
connector (P202).
• Plug the speaker connector into the lower
connector (P201).
12. Place the harness in the edge cover.
13. Reinstall the Rear Cover. (nine screws)
NOTE
Use the screw with washer to the position
indicated by the arrow.