Important Precautions - ProForm 600 User Manual

PART LISTÑModel No. PETL60000
To locate the parts listed below, refer to the EXPLODED DRAWING attached in the centre of this manual.
Key
No. Qty. Description
1 1 Motor Belt
2 1 Pulley/Flywheel/Fan
3 4 3/8Ó Motor Flange Nut
4* 1 Motor/Pulley/Flywheel/Fan
5 2 Incline Motor Bolt
6 1 Incline Motor Spacer
7 1 Incline Motor
8 1 Stop Bracket
9 2 Electronics Nut
10 4 Star Washer
11 1 Optic Switch
12 1 Frame
13 2 Electronics Bolt
14 1 Incline Optic Disk
15 8 3/8Ó Nut
16 1 UK Power Cord
17 4 Plastic Stand-Off
18 1 Hood Bracket (short)
19 1 Hood Bracket (long)
20 2 Caution Decal
21 1 Reed Switch
22 1 Reed Switch Clip
23 1 Motor/Controller Wire
24 1 Controller
25 1 Electronics Bracket
26 1 Circuit Breaker
27 1 Receptacle
28 1 Tension Bolt Sleeve
29 1 On/Off Switch
30 1 Power Inlet Bracket
31 1 Incline Leg
32 2 Frame Pivot Bolt
33 2 Frame Pivot Spacer
34 1 Upright Wire Harness
35 1 Front Roller Adj. Bolt
36 3 Roller Adj. Washer
37 2 Motor Tension Nut/Front Roller Nut
38 4 Motor Carriage Bolt
39 2 Cap Screw
40 1 Left Foot Rail Cap
41 2 Foot Rail
42 1 Front Roller/Pulley
43 1 Magnet
44 4 Platform Screw
45 4 Isolator
46 2 Isolator Screw
47 15 Fastener
48 1 Shield
49 2 Belt Guide
50 1 Book Holder
22
R0600A
Key
No. Qty. Description
51 1 Front Belly Pan
52 1 Euro Power Cord
53 4 Cable Tie Clamp
54 13 Belly Pan Screws
55 1 Walking Belt
56 1 20Ó Wire Harness
57 1 Rear Roller
58 2 Rear Isolator
59 2 Rear Foot
60 6 Rear Foot Screw
61 1 Ground Wire
62 28 Hex Screw
63 1 Belly Pan
64 1 Rear Endcap
65 2 Rear Roller Adj. Bolt
66 1 Motor
67 1 Latch Decal
68 2 Rear Platform Screw
69 2 Electronics Screw
70 1 Latch Catch
71 1 Walking Platform
72 5 8Ó Cable Tie
73 1 Jack
74 1 Motor Tension Bolt
75 2 Foot Rail Insert
76 6 Small Screw
77 1 Console
78** 2 2 lbs. (1 kg) Weight
79 1 Plastic Trim
80 1 10Õ I-Fit Wire
81 1 Circuit Board
82 1 Upright
83 2 Incline Leg Pivot Bolt
84 2 Static Warning Decal
85 2 Handrail Extension
86 2 Wheel Bolt
87 1 Console Base
88 1 Motor Tension Washer
89 10 Console/Catch Screw
90 1 Key/Clip
91 1 Incline Motor Belly Pan
92 1 Right Foot Rail Cap
93 1 Motor Tension Spacer
94 1 Motor Hood
95 2 Front Wheel
96 1 Incline Motor Shield
97 6 Base Pad
98 1 12Ó Audio Wire
99 2 Electronics Bracket Grommet 1Ó
100 1 Allen Wrench

IMPORTANT PRECAUTIONS

WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described in this
manual.
3. Place the treadmill on a level surface, with at
least 2 metres of clearance behind it. Do not
place the treadmill on any surface that blocks
air openings. To protect the floor or carpet
from damage, place a mat under the treadmill.
4. When choosing a location for the treadmill,
make sure that the location and position per-
mit access to a plug.
5. Keep the treadmill indoors, away from mois-
ture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
6. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
7. Keep children under the age of 12 and pets
away from the treadmill at all times.
8. The treadmill should not be used by persons
weighing more than 115 kg.
9. Never allow more than one person on the
treadmill at a time.
10. Wear appropriate exercise clothing when
using the treadmill. Do not wear loose cloth-
ing that could become caught in the treadmill.
Athletic support clothes are recommended for
both men and women. Always wear athletic
shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
11. When connecting the power cord (see page
8), plug the power cord into an earthed cir-
cuit. When replacing the fuse, on ASTA ap-
proved BS1362 type should be fitted to the
fuse carrier. A 13 amp fuse should be used.
No other appliance should be on the same
circuit.
12. If an extension cord is needed, use only a 3-
conductor, 1mm 2 (14 gauge) cord that is no
longer than 1.5 meters.
13. Keep the power cord away from heated sur-
faces.
14. Never move the walking belt while the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See
BEFORE YOU BEGIN on page 5 if the tread-
mill is not working properly.)
15. Never start the treadmill while you are stand-
ing on the walking belt. Always hold the
handrails while using the treadmill.
16. The treadmill is capable of high speeds.
Adjust the speed in small increments to avoid
sudden jumps in speed.
17. The pulse sensor is not a medical device.
Various factors, including the user's move-
ment, may affect the accuracy of heart rate
readings. The pulse sensor is intended only
as an exercise aid in determining heart rate
trends in general.
18. Never leave the treadmill unattended while it
is running. Always remove the key, unplug
the power cord and move the on/off switch to
the off position when the treadmill is not in
use. (See the drawing on page 5 for the loca-
tion of the on/off switch.)
19. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 6, and HOW TO FOLD
AND MOVE THE TREADMILL on page 18.) You
must be able to safely lift 20 kg in order to
raise, lower, or move the treadmill.
20. Do not change the incline of the treadmill by
placing objects under the treadmill.
21. When folding or moving the treadmill, make
sure that the storage latch is fully closed.
3