Dmx Linking; Dmx Modes; Mounting; Orientation - Chauvet LX GO User Manual

Setup

DMX Linking

DMX Modes

Mounting

Orientation

Rigging

Procedure
Product Mounting Diagram
-6-
You can link the LX Go™ to a DMX controller using a standard DMX serial connection. If
using other DMX compatible products with the LX Go™, you can control each
individually with a single DMX controller.
The LX Go™ uses the standard DMX data connection for the 3, 4, and 5 channel DMX
modes.
• Refer to the Introduction
• Refer to the Operation
modes.
• The DMX Values section will provide you with detailed information regarding the DMX
modes.
If you are not familiar with or need more information about DMX standards or the
DMX cables needed to link this product to a DMX controller, download the DMX
Primer from the CHAUVET® website: www.chauvetpro.com.
Before mounting this product, read and follow the
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
The LX Go™ includes a bracket that connects to the body of the product CHAUVET®
recommends using the following general guidelines when mounting this product.
• When selecting an installation location, consider easy access to this product for
operation, programming adjustments, and routine maintenance.
• Make sure to mount this product away from any flammable material as indicated in
the Safety Notes.
• Never mount in places where rain, high humidity, extreme temperature changes, or
restricted ventilation may affect the product.
• If hanging this product, make sure that the mounting location can support the
product's weight. Refer to the
requirements of this product.
• When hanging this product, always secure to a fastening device using a safety cable
(included).
The LX Go™ comes with a mounting bracket to which you can attach mounting clamps
for hanging. You may also use the bracket to mount it to almost any surface using
screws. Make sure all hardware and surfaces are capable of supporting the product's
weight. You will have to use at least 1 mounting point per product.
Mounting
Screws
Floor Mounting
chapter for a brief description of these modes.
chapter to learn how to configure the LX Go™ to work in these
Technical Specifications
Clamp
Safety Notes in this manual.
chart for the weight-bearing
Overhead Mounting
LX Go™ User Manual Rev. 4