Playback Mode; Playing Back A Tape; Finding A Scene You Want To Play Back - Panasonic Palmcorder MultiCam PV-GS2 Operating Instructions Manual

Playback Mode

Playing Back a Tape

The recorded scene can be played back immediately
after the recording.
1 Set the [OFF/ON] Switch
• The [POWER] Lamp
40
37
2 Set the Mode Dial
36
36
3 Press the [ ] Button
tape.
16
• Rewind the tape to the point where you want to
start playback.
• When the tape reaches the beginning, rewinding
stops automatically.
4 Press the [►] Button
• The [ ] Indication appears.
14
• If a cassette recorded with copyright protection
signal is played back, the picture is distorted by
mosaic-like patterns.
To Stop Playback
Press the [ ] Button
15
15
Playback Mode
to [ON].
40
37 lights up.
to Tape Playback Mode.
to rewind the
16
to start playback.
14
.
Adjusting the Sound Volume
To adjust the volume, push the [W/T] Lever
display the [VOLUME] Indication. Push the [W/T]
Lever towards [T] to increase the volume or push
the [W/T] Lever towards [W] to decrease the
volume. The [VOLUME] indication disappears
immediately after adjustment is made.
24
To adjust the volume with the Remote Control,
press the [T] or [W] Button to display the [VOLUME]
Indication. Press the [T] Button to increase the
volume or press the [W] Button to decrease the
volume. The [VOLUME] indication disappears
immediately after adjustment is made.
• The sound volume cannot be adjusted using the
Remote Control in Playback Zoom Mode. (pp. 35-36)
• For other notes concerning this item, see page 59.
Finding a Scene You Want to Play
Back
Cue/ Review Playback
13
16
If the [ ] Button
13
pressed during Playback, it turns to Cue Playback
or Review Playback
A
A
• If the Button is held continuously, it turns to Cue
Playback or Review Playback until you release it.
24
or [ ] Button is
16
.
B
B
to
33