Charging Time And Available Recording Time; The Grip Belt; Re-Attaching The Lens Cap - Panasonic Palmcorder MultiCam PV-GS2 Operating Instructions Manual

2 Attach the charged Battery to the Camcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch
sliding the [BATTERY RELEASE] Switch
remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the [OFF/ON]
Switch to [OFF] and make sure the [POWER] Lamp
is not lit.
• For other notes concerning this item, see page 56.
Charging Time and Available
Recording Time
CGR-D08R
Charging Time
A
Maximum Continuous Recording Time
B
• "1 h 30 min." indicates 1 hour and 30 minutes.
• Battery CGR-D08R is supplied.
• The times shown in the table are approximate
times. The numbers indicate the recording time
when the Viewfi nder is used. The numbers in
parentheses indicate the recording time when the
LCD Monitor is used. In actual use, the available
recording time may be shorter.
• The times shown in the table are for continuous
recording at a temperature of 68 °F (25 °C) and
humidity of 60 %. If the Battery is charged at a
higher or lower temperature, the charging time
may be longer.
• The available recording time becomes shorter
if you use both of Viewfi nder and LCD Monitor
simultaneously when rotating the LCD Monitor
forward to record yourself or setting [EVF
ON/AUTO] to [ON].
14
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
to [OFF], and while
40
,
44
40
44
A
1 h
B 2 h 10 min. (1 h 45 min.)
Before Use

The Grip Belt

To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your
hand.
1 Detach the end of the Grip Belt.
2 Adjust the length of the Grip Belt to the size
of your hand.
3 Reattach the Grip Belt.

Re-attaching the Lens Cap

To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come preattached
to the Grip Belt.
1 Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then pass
the Lens Cap through the loop made by itself
and pull tight.
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
1
1
2
2