Power Supply - Panasonic Palmcorder MultiCam PV-GS2 Operating Instructions Manual

Using the Remote Control (Optional)
• Remote Control is not supplied, If you would like
to order, the parts number is LSSQ0411 as a
replacement parts. Please refer to page 69.
1 Direct the Remote Control at the Remote
Control Sensor
29
press an appropriate button.
15°
15°
15°
15°
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical and
horizontal directions from the central axis
• The above operating ranges are for indoor use
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder and
that of the Remote Control do not match, [CHECK
REMOTE MODE (REMOTE)] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Control Mode. (p. 19)
Setup on the Remote Control:
2
[VCR1]:
Press the [ ] Button and [
simultaneously.
1
[VCR2]:
Press the [ ] Button and [
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
of the Camcorder and
29
1
] Button
] Button
Before Use

Power Supply

Using the AC Adaptor
1 Connect the DC Cable to the Camcorder.
2 Connect the DC Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor and
the AC Jack.
• Before connecting or disconnecting the power
supply, set the [OFF/ON] Switch
Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit. (p. 16)
Using the Battery
Before use, fully charge the Battery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
• Since the Battery will not be charged when the DC
Cable is connected to the AC Adaptor, disconnect
it from the AC Adaptor.
• The [POWER] Lamp and [CHARGE] Lamp light
up, and charging starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at fi rst, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer than
usual.
on the
40
13