Base - AT&T Marathon User Manual

Getting started
Adding and registering a headset
Option 2: To register the headset to an AT&T DECT 6.0 cordless
telephone base
1. You must deregister the headset from the
headset base (see page 21).
2. Make sure the battery is properly installed in
the headset (see page 8). The ON/OFF light
flashes twice every five seconds to indicate
that the headset is not registered.
3. Place the headset in the headset base and
allow it to charge for at least five minutes
before beginning the registration. Remove the
headset from the headset base and then place
the headset back into the headset base.
4. On the telephone base of the cordless phone,
press and hold
FIND HS button until the IN USE light turns
on (about four seconds) and then release
the button.
If your telephone base has no
HANDSET LOCATOR or
Press and hold the HOLD button until the screen displays
Registering... Please wait, then release the button.
-OR-
Press and hold the
Registering handset..., then release the button.
5. The headset is registered to the telephone base automatically. It
may take about 30 seconds to complete. The headset ON/OFF
light turns on. To verify the registration was successful, press
the ON/
OFF
NOTES:
If the registration fails, the ON/OFF light on the headset flashes twice every
•
five seconds. Reset the headset and try again. Remove the headset from the
headset base and press ON/OFF. Place the headset back into the headset
base. Try the registration process again.
• For users of Synapse® or SynJ®, refer to the user's manual of your respective
model for registration instructions.
Synapse® and SynJ® are registered trademarks of Advanced American Telephones.
HANDSET LOCATOR or
LOCATOR button until the screen displays
button and check for a dial tone.
FIND HS button:
20