No Lifter Mode Or Lifter Mode - AT&T Marathon User Manual

Getting started
Headset base installation

No lifter mode or lifter mode

There are two answer modes available on the
headset base. The current mode is indicated
by the NO LIFTER MODE or LIFTER MODE lights
on the front of the headset base.
• When plugging your headset base into the
telephone wall jack (installation option 1
or 2), make sure the headset base mode is set
to NO LIFTER MODE.
-OR-
• When connecting your headset base to a multiple line corded
telephone (installation option 3), make sure the headset base
mode is set to LIFTER MODE and that the LIFTER AUDIO ADJUST
is switched for the best headset audio quality (see page 17).
To change the answer mode:
When the headset is not in use, press MODE on the headset
base to select NO LIFTER MODE or LIFTER MODE. The
corresponding light on the front of the headset base turns on to
indicate the current mode.
For complete instructions on installing and using the handset
lifter, see the handset lifter user's manual.
NOTE: If you are using the handset lifter, you must use LIFTER MODE.
11
MODE