Rear-Wheel Stand - BMW K 1300 R Rider's Manual

8
104
If the motorcycle is on the
centre stand and is raised
too far, the centre stand will lift
clear of the ground and the mo-
z
torcycle could topple to one side.
When raising the vehicle, make
sure that the centre stand re-
mains on the ground.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.

Rear-wheel stand

Installing rear-wheel
stand
Use basic stand with tool num-
ber (83 30 0 402 245) in com-
bination with rear-axle adapter
(83 30 0 402 250).
Use screws 1 to set the rear-
wheel stand to the desired
height.
Remove retaining disc 2. To
do so, press release button 3.
Make sure the ground is level
and firm and place the motor-
cycle on its side stand.
Push the rear wheel stand from
the left into the rear axle.
Push on retaining disc 2 from
the right, while holding the re-
lease button down.
Hold the motorcycle upright
and at the same time press the