Setting The Synchro Scan Mode; Selecting The Recording Signals And Recording System; Selecting The Audio Input Signals And Adjusting Their Recording Levels; Selecting The Audio Input Signals - Panasonic AJ-HDX400P Operating Instructions Manual

Chapter 4 Adjustments and settings for recording

4-2-3 Setting the synchro scan mode

Proceed with operation by following the steps below.
1
Press the SHUTTER switch from ON to SEL to establish
the SYNCHRO SCAN mode.
SHUTTER switch
2
In the SYNCHRO SCAN mode, it is possible to change
the shutter speed continuously within a range from 1/60.3
sec. to 1/249.8 sec. by operating the SYNCHRO SCAN (+
and –) buttons.
4-3 Selecting the recording signals
and recording system
This unit cross-converts 720/59.94P drive camera signals to
the 1080/59.94i system signals and records them using the
DVCPRO HD EX format.
30
SYNCHRO SCAN (+ and –) buttons

4-4 Selecting the audio input signals

and adjusting their recording
levels
When the AUDIO SELECT CH1/CH2 switch is set to AUTO,
the recording levels on audio tracks CH1 and CH2 are
adjusted automatically. On the other hand, when it is set to
MAN, the levels can be adjusted manually. The recording
levels on audio tracks CH3 and CH4 can be selected using
the menu.
4-4-1 Selecting the audio input signals
Use the AUDIO IN switch to select the input signals to be
recorded on audio tracks CH1, CH2, CH3 and CH4.
For details, refer to "2-2 Audio function section."
MONITOR
CH1/3OSTOCH2/4
selector switch
MONITOR SELECT
CH1/2OCH3/4 switch
AUDIO SELECT
CH1, CH2 buttons
Display window
AUDIO LEVEL
CH1, CH2 controls