Flexiblelom Enablement Option - HP ProLiant DL180 Gen9 User Manual

Secure the GPU power cable in the two front chassis cable clips.
c.
Install the Smart Storage Battery holder.
11.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all expansion slots have either an expansion slot cover or an expansion board installed.
Install the access panel (on page 25).
12.
Do one of the following:
13.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
14.

FlexibleLOM enablement option

This section provides instructions for installing the FlexibleLOM enablement option to support an HPE
FlexibleLOM adapter in this server.
The FlexibleLOM riser board in this enablement option has three slots. The top two slots are for general
expansion board installation and the bottommost slot is reserved for FlexibleLOM adapter installation. For
more information on the riser board slot specifications, see "PCIe riser board slot definitions (on page
12)."
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
("Installing the server into the rack" on page 35).
Hardware options installation 95