HP ProLiant DL180 Gen9 User Manual page 73

Install the optical drive into the bay.
8.
If an expansion board is installed in the primary PCI riser cage, then remove the PCI riser cage
9.
("Remove the PCI riser
Connect the optical drive cable:
10.
Connect the optical drive cable to the optical drive.
a.
Connect the four-pin (2x2) power supply cable to the power connector of the optical drive cable.
b.
Secure the optical drive cable in the two front chassis cable clips.
c.
Connect the cable to the SATA connector on the system board.
d.
If removed, install the primary PCI riser cage
11.
Install the access panel (on page 25).
12.
If removed, install the security bezel
13.
Do one of the following:
14.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
15.
cages" on page 26).
("Install the PCI riser
("Security bezel
("Installing the server into the
cages" on page 27).
option" on page 41).
rack" on page 35).
Hardware options installation 73