HP ProLiant DL180 Gen9 User Manual page 52

Connect the BP1 power connector of the LFF power cable to the 4-bay LFF hot-plug drive cage
15.
backplane.
To connect the 4-bay LFF hot-plug drive backplane to the onboard controller, connect the 520-mm
16.
Mini-SAS cable:
Connect the Mini-SAS cable to the system board.
a.
Route the Mini-SAS cable along the side of the system board towards the front chassis, and then
b.
connect the cable to the drive backplane.
Secure the Mini-SAS cable in the right front chassis cable clip.
c.
Install the air baffle (on page 29).
d.
Install the primary PCI riser cage
e.
To connect the 4-bay LFF hot-plug drive backplane to an HBA option, connect the 540-mm Mini-SAS
17.
cable:
("Install the PCI riser cages" on page 27).
Hardware options installation 52