Troubleshooting - InFocus INF6502WB User Manual

TROUBLESHOOTING

SYMPTOM
No power
The monitor shuts down suddenly • Verify that a source is active.
No image
No image from external source
The colors on the monitor do not
look right
No touchpad activity with
external computer
Touchpad functions are not
functioning consistently
Remote is not working
Audio noise
INF6502WB User Guide
POSSIBLE SOLUTIONS
• Verify the power cord is properly connected to the power outlet and to
the monitor.
• Verify the power switch is ON and that the Power button on the remote or
keypad has been turned on (the front LED should be green).
• Plug another electrical device to the power outlet to verify that the outlet is
supplying the proper voltage.
• The monitor may have overheated. Remove any objects blocking the vents.
• If attempting to display an external source, see "No image from external
source" below.
• Verify that the monitor is turned on (the front LED should be green).
• Verify that connections between the source and the monitor have been
made correctly.
• Verify that the cables are in good condition.
• Verify the correct input source is selected and that the input signal is
compatible with the monitor.
• Adjust the color settings in the Picture menu.
• Reset the picture settings.
• Verify that connections between the source and the monitor have been made
correctly.
• Verify that the cables are in good condition.
• Verify that the USB B to USB type A cable is plugged from the laptop into the
monitor correctly.
• Verify that the laptop's operating system is Windows® 7 or 8. (The monitor
touchpad does not support any other operating systems.)
• Remove all objects placed on the lip of the monitor and/or within 2" of the
touchpad screen.
• Disable the PiP feature.
• Power the device off and back on after a few seconds. Re-booting the device
helps the touchpad to re-synchronize.
• Make sure the batteries are installed in the proper orientation and are not dead.
• Verify the remote is turned on (the button is on the bottom of the remote).
• Verify you are pointing the remote at the table and are within 26' (8m) and 30
degrees (horz/vert) of the sensor.
• Verify that the IR Control setting in the Advanced Option OSD menu is set
to Normal.
• Noise can occur when infrared communication equipment (for example,
infrared cordless headphones) is used near the monitor. Move the infrared
communication equipment away from the monitor to eliminate the noise.
Page 35