Advertisement
Caution: The RS-232 serial port on the camera is not a
network connection.
8.
Re-attach the bubble by screwing it to the housing.
9.
See "Accessing the camera over the internet" on page 4 to
configure the camera over the internet. Refer to the
Configuration Manual for detailed information.
TVP-1122/3122 pendant-mount camera
1.
Prepare the mounting surface and install the camera
bracket.
2.
Attach the safety cable to the bracket and then route the
cables from the pendant bracket as shown below.
3.
Connect the cables to the PCB of the module through the
cable entry hole on top of the housing.
4.
See "Accessing the camera over the internet" on page 4 to
configure the camera over the internet. Refer to the
Configuration Manual for detailed information.
Flush-mount camera
1.
Drill a hole on the ceiling using the drill template.
2.
Tie three safety cables (not supplied) to the safety hooks
on the camera and hang the camera from a secure point.
P/N 1073029-EN • REV A • ISS 03JUN15
Safety cable
3.
Unscrew the bubble from the camera and remove the
protective tape from the PTZ module.
4.
Press the two tabs on either side of the PTZ module and
remove it from the camera housing.
5.
Route the cables from the bracket and connect them to
the PCB of the module through the cable entry hole on the
top of the housing.
Note: If alarm and audio input/output relays are to be used, also
connect them to the PCB of the module.
6.
Adjust the height of the two housing tabs by turning the
screw on which they are attached. The distance (h) of the
tabs from the housing ring must be greater than the
thickness of the ceiling.
Housing tab
Screw
7. Make sure the housing tab is closed and then PUSH the
housing into the pass-through hole. Hold the housing and
fix it by screwing the housing tabs down to the mounting
surface
8.
Insert the PTZ module into the housing:
9.
Re-attach the bubble by screwing it to the housing.
10. Install the trim ring. Align the trim ring to the housing, and
insert the fix-pins to the holes. Then rotate the ring
clockwise to secure.
11. See "Accessing the camera over the internet" on page 4 to
configure the camera over the internet. Refer to the
Configuration Manual for detailed information.
3 / 6
Advertisement
