Installing Your Machine
Optional Telephone Handset Jack
or External Telephone Jack
Connect the Telephone Line Cable from the
Optional Handset Kit into the HANDSET
jack on the back of the machine.
or
You can connect an additional standard
single line telephone to the machine.
To connect a telephone,
remove the protective tab on the TEL jack.
RJ-11C
Telephone Jack
Handset Kit (Optional)
(UE-403185)
(Some models may have
the Power Switch.)
Power Cord (Included)
LAN Cable
(10BASE-T/100BASE-TX Cable)
Insert the plug until a click is heard.
(LAN cable is not included with the product.)
Purchase a Category 5 Cable, compliant with
EIA/TIA 568-A-5 standard.
10BASE-T/100BASE-TX Ethernet Hub
Ethernet LAN
(10BASE-T/100BASE-TX
Cable not included)
1
NOTE
1. Please observe the standards for USB cables.There is a danger that circuit board could be damage by voltage difference.
It is recommended that identical cable taps be used to supply power.
Optional 2nd Telephone Line Jack
(Optional G3 Communication Port Kit
POWER
(Service use only)
(UE-407029) is required.)
Telephone Line Jack
Plug one end of the Telephone
Line Cable into the telephone
jack supplied by the telephone
company and the other end into
the LINE jack on the back of
the machine.
USB Port
See Operating Instructions
(For Document Management
System)
RX Lamp (orange)
Blinks when there is data
traffic on the LAN.
LAN Connection Jack
(10BASE-T/100BASE-TX)
LINK Lamp (green)
Illuminates when connected
to the LAN.
Lamp will not turn ON if LAN
cable is defective (contains breaks).
25